Продам лампы JJ-electronic (slovakia) для усилителй, преампов и т.д., Киев. Отправка по Украине. Опції

[Suisider]

Лампы JJ-electronic - можно назвать одними из самых надежных и в тоже время музыкально звучащих ламп производимых в мире на сегодняшний день. Когда-то известный своими надежными електронными компонентами и аппаратурой советских времен завод TESLA в 1994 обрел новых хозяев и новое название - JJ-electronic.

Всегда в наличии:

ECC83 (12AX7)
ECC82 (12AU7)
ECC81 (12AT7)

EL84 (поштучно, пары, четверки)
EL34 (поштучно, пары, четверки, шестерки)
E34L (поштучно, пары, четверки, шестерки)
6L6GC (поштучно, пары, четверки, шестерки)
6V6S (поштучно, пары, четверки)
KT66 (поштучно, пары, четверки, шестерки)
KT77 (поштучно, пары, четверки, шестерки)
KT88 (поштучно, пары, четверки, шестерки)

а также доступны все продукты http://www.jj-electronic.sk/

Внимание! Все лампы тестированные. Оконечные пары,четверки и шестерки тщательно подобраны по току. Для Marshall, Peavey, Mesa, Orange, Fender, Laney и других. Помогу с выбором конфигурации. Остерегайтесь подделок и ламп "из кучи" и помните что скупой платит дважды.

Контакт:

Все вопросы касательно замены в усилителях, цен ,способов оплаты и доставки писать прямо мне в ЛИЧНЫЕ СООБЩЕНИЯ или в аську 309-391-5шесть5 .
[size=6]




Я занимаюсь JJ c 2008 года. В теме (которая висела с 2008 года и недавно загадочно исчезла) было много положительных отзывов о моей работе ( о чем еще может свидетельствовать дата регистрации моего акаунта здесь).

Приєднані зображення

 

[Костя]

Ну вот мужик вполне внятно расписал что к чему, довольно понятно даже мне.

KT88's in a Dual Rectifier??

Yes! KT88's in a DR... This is one way to make a DR into "Frankin Rectifier" The bias on the DR's is set very cool for 6L6's and EL34's but the average KT88 draws about double the natural plate current of the average 6L6 so when you run KT88's in a DR with the amp in the EL34 rectifier mode the bias comes up to where it should be and the bottom end gets VERY deep and strong along with a punch that is truly enormous!

May the amplifier Gods have mercy on your speakers!!

I would also like to dispel a couple myths that I've read lately on the Harmony Central forum about KT88's ( yes I do read the forum every once in a while when I have the time ). First off Dual Rec's are capable of using either 6L6's or EL34's and LOTS of you DR players out there are using the JJ E34L's in your amps and have been doing so for years. A standard 6L6 draws .9 amps of heater current where the JJ E34L draws 1.5 amps. A KT88 draws 1.6 amps so as you can see a quad of KT88's will only draw .4 amps more that a quad of E34L's and is not going to cause a problem. Hell I even use a quad of KT88's in my 1982 Evil Twin which means that it's having to deal with a 6.4 amp draw instead of a 3.6 amp draw from a quad of 6L6's and it's been running STRONG for almost four years now. My 5150ex has a total draw of 6.2 amps running two KT88's and two E34L's once again this amp was made for a quad of 6L6's with a total draw of 3.6 amps and yes, it's a MONTSER and gets played very hard and often now for over two years. The bottom line is that most of the amps out there that can run 6L6's can run E34L's or even KT88's if there is room and the bias is set properly.

Now about that pesky bias question. Dual Rec's are a unique amp because of the different settings available with the "spongy" and "bold" settings along "6L6" and "EL34" settings and the "solid state" and "rectifier" modes. Since a KT88 will draw almost twice the natural plate current that an average 6L6 draws your bias will go up! An average E34L will draw only about half the natural plate current that an average 6L6GC draws. When a DR customer calls me and is looking for an improvement in his clean tone and an improvement in dynamics I will often recommend using the JJ 6L6GC's in a cooler grade and running in the "EL34" mode which will get a DR to draw about 32 to 40mA per tube depending on whether it's run is SS, REC, Bold or Spongy. This gets the bias much closer to where it actually belongs when using a cooler grade of 6L6.

An amp that has anywhere from 450 to 500 plate volts can run a JJ KT88 at between 50mA and 90mA per tube. Here's a quick run down on the bias of moderate grade JJ KT88's in a DR.

These setting are in the "6L6" mode.

Rectifier mode in spongy setting = 16mA which is VERY cold so you can imagine how cold a 6L6 would be!

Rectifier mode in bold setting = 18mA which is still VERY cold.

Solid State mode in spongy setting = 28mA still cold.

Solid State mode in bold setting = 32mA still a little cool.

These setting are in the "EL34" mode.

Rectifier mode in spongy setting = 44mA which is actually just getting out of crossover distortion and sounds very good.

Rectifier mode in bold setting = 50mA nice an aggressive with great dynamics.

Solid State mode in spongy setting = 78mA now this is getting some heat in the tubes and the dynamics are spectacular.

Solid State mode in bold setting = 88mA this is getting up to about 80% of max dissipation and will shorten the tube life about 10 to 15% and the tone will start to "brown" but it's a lovely sound!

Now I do want touch on one more thing that is a big myth. Just because a JJ KT88 will actually dissipate 50 watts does NOT mean that because you use a quad in a DR you will have a 200 watt amp! It doesn't work that way. To get more power from an amp the plate voltage needs to increase and you can't do that unless you replace the transformers to supply a higher plate voltage ( please no questions... ) For instance my Twin when loaded with JJ 6L6GC's will make right at 90 watts before clipping and loaded with a quad of JJ KT88's it makes 98 watts before clipping which is not much and is basically perceived as a little more headroom. You have to double your wattage to gain 3db so if you calculate the difference the KT88's will breakup only a fraction of 1db louder than the 6L6's.



Anyone reading this has my full permission to post it on HC or anywhere else.

[Suisider]

Ну вот мужик вполне внятно расписал что к чему, довольно понятно даже мне.

Я знаком с этим мужиком лично))))) и вот что он мне написал в почту

Hi Andre:



You can use KT88’s and 6L6GC’s together in the 6L6 mode. You cannot run KT88’s and EL34’s together.